UNIFY PRO MOUNTING BOARD

UNIFY PRO MOUNTING BOARD

review
0
0
5
Your Price: $5.99
In Stock.
Part Number:WHITENOISE

Choose Options

VTX Compatability
PLEASE MAKE SURE YOU SELECT THE CORRECT VERSION.  THE Unify Pro V2 (5V) will NOT work with the RACE/HV versions.

Allows a Team BlackSheep Unify Pro and FrSky D4R or X4R-SB to be mounted on a board for a low profile and clean stacking solution.  The pads around the Unify are meant to hard mount the video transmitter to the board.  Once the Unify is mounted, you can either use the plug that comes with the Unify or directly solder the wires to the pads.  The button extension can also be used with this by connecting one of the pads of the button to the board.  From there, you can use the button extension with the Riptide LED Back Plate.  

The FrSky receivers do not have to be used with this board.  Spektrum, Futaba, etc receivers can work.  You can connect the receiver directly to the flight controller (ignore the receiver portion on the board) or connect the receiver to one of the header pins on the Unify Mounting Board and use the pads as intended.  The solder bridge pads will still have to be used to select which headers you will be using.  

Full Size Designed For:
  • TBS Unify Pro Video Transmitters
  • FrSky D4R-II, X4R-SB
  • Can also work with Spektrum, Futaba, or any other receiver
Nano Features
  • TBS Unify Pro Nano Video Transmitter support
  • 4 plated through holes for mounting receivers
  • Pads for camera pigtail
  • Top or side pads for VTX button
  • 20mm x 20mm hole pattern
  • 27mm x 26mm dimensions

The Nano-Nano board was designed to allow you to mount your Team BlackSheep Unify Pro Nano VTX in your stack for cleaner builds.  This board includes holes that are compatible with (but not limited to) most receivers such as the FrSky XM+ and Team BlackSheep Crossfire Nano.  Once the VTX is soldered into the cutout on the board, the breakout pads on the side allow for full access to your VTX.  

If your camera uses 5V for power, you can solder your pigtail to the camera pads and allow the board to act as a pass through.  After your VTX, camera, and receiver is installed, the 5V pad on the board will power all your components.

There are also two pads located on the side of the board to solder the button that's included with your Unify Nano.  The button can be soldered top facing, side facing, or with wires to allow for access to the VTX from anywhere.  

Note: If your receiver requires 3V, you will need to pull power from somewhere else.  Do not solder in the 5V header if your receiver is not compatible.  You can use the other plated through holes (1, 2, and ground) for your receiver still.


Related Items